Fratelli Vimercati

The product line of PHB press brakes with torsion bar features is characterized by high reliability, bending quality and usage ease.
The control panel includes a PRG920 2-axis electronic programmer by Nuova Elettronica which enables the automatic setup of the Ram-travel down stroke height of axis Y (angle) and the positioning of the back motor-driven gauge X. Two-speed electrical motors with electrical brake provide to position the two axes.
The control panel allows setting up the top dead centre, the speed change point and the operating pressure.
These features allow higher speed and processing accuracy.

• Working length from 2085 mm to 6050 mm
• Distance between the uprights from 1560 mm to 5065 mm
• Nominal operating power from 500 kN to 2000 kN (from 50 to 200 tons)
• RAM Travel / Upper blade holder stroke from 170 mm to 220 mm
• Back gauge stroke 700 mm
• Down stroke speed from 80 to 100 mm/sec
• Up stroke speed from 80 to 100 mm/sec
• Operating speed 10 mm/sec
• Blade holder/plate distance (clearance table/RAM) from 360 mm to 420 mm
• Throat depth from 300 mm to 500 mm
• Motor-driven setup of the bottom dead centre with PRG920 positioning device
• Motor-driven back gauge with PRG920 positioning device – two speeds and recirculating ball screws – (Nuova Elettronica) and tilting stops
• Pedals for remote control
• Photocells
• Safety devices according to the regulations in force
• Centralized lubrication with manual pump
• Service key
• Instruction manual according to EC standards

• Segmented and special tools
• Ground hardened tools
• Tool holders for upper tools
• Self-centring single-slot lower tools
• Automatic lubrication
• Camber plate with manual adjustment wedges
• Front supports with retractable stops
• Extra fingers
• Multiple-axis CNC programmers
• Throat depth over sizing